Numerical Modeling of Earthquake-Induced Landslide Using an Improved Discontinuous Deformation Analysis Considering Dynamic Friction Degradation of Joints
ROCK MECHANICS AND ROCK ENGINEERING
Authors: Huang, Da; Song, Yixiang; Cen, Duofeng; Fu, Guoyang
Abstract
Discontinuous deformation analysis (DDA) as an efficient technique has been extensively applied in the dynamic simulation of discontinuous rock mass. In the original DDA (ODDA), the Mohr-Coulomb failure criterion is employed as the judgment principle of failure between contact blocks, and the friction coefficient is assumed to be constant in the whole calculation process. However, it has been confirmed by a host of shear tests that the dynamic friction of rock joints degrades. Therefore, the friction coefficient should be gradually reduced during the numerical simulation of an earthquake-induced rockslide. In this paper, based on the experimental results of cyclic shear tests on limestone joints, exponential regression formulas are fitted for dynamic friction degradation, which is a function of the relative velocity, the amplitude of cyclic shear displacement and the number of its cycles between blocks with an edge-to-edge contact. Then, an improved DDA (IDDA) is developed by implementing the fitting regression formulas and a modified removing technique of joint cohesion, in which the cohesion is removed once the 'sliding' or 'open' state between blocks appears for the first time, into the ODDA. The IDDA is first validated by comparing with the theoretical solutions of the kinematic behaviors of a sliding block on an inclined plane under dynamic loading. Then, the program is applied to model the Donghekou landslide triggered by the 2008 Wenchuan earthquake in China. The simulation results demonstrate that the dynamic friction degradation of joints has great influences on the runout and velocity of sliding mass. Moreover, the friction coefficient possesses higher impact than the cohesion of joints on the kinematic behaviors of the sliding mass.
Simultaneous Determination of Four Aflatoxins in Dark Tea by Multifunctional Purification Column and Immunoaffinity Column Coupled to Liquid Chromatography Tandem Mass Spectrometry
JOURNAL OF AGRICULTURAL AND FOOD CHEMISTRY
Authors: Ye, Ziling; Cui, Pu; Wang, Yong; Yan, Hangbin; Wang, Xu; Han, Sanqing; Zhou, Yu
Abstract
Dry tea matrix contains an abundance of caffeine and polyphenols which are different from the food matrix (e.g., protein, lipid, and carbohydrates), and only a few studies have tried aflatoxins determination with tea samples. Here, a specific, accurate, and sensitive method was developed and validated for the simultaneous determination of aflatoxin B1, B2, G1, and G2 in dark teas. Aflatoxins were extracted by acetonitrile/water, press-filtered, and cleaned by multifunctional purification column (MFC) and immunoaffinity column (IAC) in tandem. The cleaned extract was analyzed by liquid chromatography tandem mass spectrometry. The matrix interference was effectively reduced by MFC-IAC cleaning method. Recoveries at the spiking concentrations of 5-60 mu g/kg ranged from 77.5 to 93%, with relative standard deviations <11.0%. The correlation coefficients of aflatoxins standard were >0.998. The limits of detection were 0.024-0.21 mu g/kg and the limits of quantification were 0.08-0.74 mu g/kg. The intra- and interday accuracy ranged from 74 to 87%, and the intra- and interday precisions ranged from 0.4 to 3.1%. After the method validation, the aflatoxins contaminations in 100 collected dark teas were detected, and the results were compared with those of other methods.