Catalog of total excitation-emission and total synchronous fluorescence maps with synchronous fluorescence spectra of homologated fluorescent pesticides in large use in Morocco: development of a spectrometric low cost and direct analysis as an alert method in case of massive contamination of soils and waters by fluorescent pesticides
ENVIRONMENTAL SCIENCE AND POLLUTION RESEARCH
Authors: Foudeil, S.; Hassoun, H.; Lamhasni, T.; Ait Lyazidi, S.; Benyaich, F.; Haddad, M.; Choukrad, M.; Boughdad, A.; Bounakhla, M.; Bounouira, H.; Duarte, R. M. B. O.; Cachada, A.; Duarte, A. C.
Abstract
The purpose of this research is to develop a direct spectrometric approach to monitor soils and waters, at a lower cost than the widely used chromatographic techniques; a spectrometric approach that is effective, reliable, fast, easy to implement, and without any use of organic solvents whose utilization is subject to law limitation. It could be suitable at least as an alert method in case of massive contamination. Here, we present for the first time a catalog of excitation-emission and total synchronous fluorescence maps that may be considered as fingerprints of a series of homologated pesticides, in large use in Morocco, aiming at a direct detection of their remains in agricultural soils and neighboring waters. After a large survey among farmers, agricultural workers and product distributors in two important agricultural regions of Morocco (Doukkala-Abda and Sebou basin), 48 commercial pesticides, which are fluorescent, were chosen. A multi-component spectral database of these targeted commercial pesticides was elaborated. For each pesticide, dissolved in water at the lowest concentration giving a no-noise fluorescence spectrum, the total excitation-emission matrix (TEEM), the total synchronous fluorescence matrix (TSFM) in addition to synchronous fluorescence spectra (SFS) at those offsets giving the highest fluorescence intensity were recorded. To test this preliminary multi-component database, two real soil samples, collected at a wheat field and at a vine field in the region of Doukkala, were analyzed. Remains of the commercial Pirimor (Carbamate) and Atlantis (Sulfonylurea) were identified by comparison of the recorded TEEM, TSFM, and SFS to those of the preliminary catalog at one hand, and on the basis of the results of a field pre-survey. The developed approach seems satisfactory, and the fluorimetric fingerprint database is under extension to a higher number of fluorescent pesticides in common use among the Moroccan agricultural regions.
Terrestrial structure-from-motion: Spatial error analysis of roughness and morphology
GEOMORPHOLOGY
Authors: Schwendel, Arved C.; Milan, David J.
Abstract
Structure-from-Motion (SfM) photogrammetry is rapidly becoming a key tool for morphological characterisation and change detection of the earth surface. This paper demonstrates the use of Terrestrial Structure-from-Motion (TSfM) photogrammetry to acquire morphology and roughness data at the reachscale in an upland gravel-bed river. We quantify 1) spatially-distributed error in TSfM derived Digital Elevation Models (DEMs) and 2) identify differences in roughness populations acquired from TSfM photogrammetry versus TLS. We identify an association between local topographic variation and error in the TSfM DEM. On flatter surfaces (e.g. bar and terrace surfaces), the difference between the TSfM and TLS DEMs are generally less than +/- 0.1 m. However, in areas of high topographic variability (>0.4 m) such as berm or terrace edges, differences between the TSfM and TLS DEMs can be up to +/- 1 m. Our results suggest that grain roughness estimates from the TSfM point cloud generate values twice those derived from the TLS point cloud on coarse berm areas, and up to four-fold those derived from the TLS point cloud over finer gravel bar surfaces. This finding has implications when using SfM data to derive roughness metrics for hydrodynamic modelling. Despite the use of standard filtering procedures, noise pertains in the SfM DEM and the time required for its reduction might partially outweigh the survey efficiency using SfM. Therefore, caution is needed when SfM surveys are employed for the assessment of surface roughness at a reach-scale. (C) 2019 Elsevier B.V. All rights reserved.